https://www.repairmywindowsanddoors.co.uk/dover-cat-flap-installer-near-me/ The process of installing a cat flap may be a bit daunting but it's simple to install by following the correct instructions. Firstly, determine how high you want the cat flap to be (on average or belly height). Mark this point on the door and use the template included as a reference to drill. If you have a young kitten you can prop the door open a bit and gradually push it to go through. Reward it each time it goes through. Measure the Door A cat flap is a wonderful way to allow your pet to come and go into and out of your home whenever it pleases. This will keep your cat healthy as it will ensure that it gets enough exercise and also be able to go back inside when it is stranded outside in bad weather. This will reduce the amount of time you allow your cat go in and out and also make your home secure by notifying you when it has left. However, it is essential that the flap for your cat is correctly fitted to prevent your pet from escaping through it or be pushed through by any other animals (e.g. dogs). It is crucial to determine your pet's belly height and the entrance to your home so that you can ensure that the flap is at the proper height. You can adjust the position of your flap in case your cat is smaller or taller than average. The next step is to use a spirit level to mark the middle of the door. This is where you will put in the flap. With the markings as a guideline, you can use an jigsaw to cut the form of the flap inside the door. After cutting the area then sand the edges to create smooth surfaces. Drill any holes you need to. The process of installing a cat flap is not as difficult as you believe and it shouldn't take more than two hours to complete the entire process from beginning to finish. The process can be slightly more complicated if you are required to install it in the form of a uPVC door or a composite one. This is because these doors come in different thicknesses, w