https://www.repairmywindowsanddoors.co.uk/eastleigh-cat-flap-installer-near-me/ If you're looking for an option to let your pet in and out without worrying about them leaving unwelcome "gifts" in the house you should consider purchasing an upvc door panel that has a cat flaps. This option is less expensive than replacing the entire door and is simpler to install. While it is possible to install a cat flap into your own uPVC door, it is important to understand that this is a tricky job that could result in costly mistakes. Easy to install It's important that you can allow your pet into and out of the house. This will not just ensure your pet's safety, but it will also stop unwanted draughts or moisture in your house. You can also save money by letting your pet assist with cooling and heating. However, installing an animal flap inside a uPVC door can be difficult for homeowners who aren't experts. There are ways to simplify the process. You must first measure the height of your pet. This will allow you to determine the correct height for the flap. You will then need to draw the desired shape on the uPVC panel. This can be an oval or a square. You should also make sure that the cut is correct and that the cut is straight. Once you've marked the mark on the uPVC panel then you can use a jigsaw to cut out the design. Use a blade that is fine-tipped and is typically marked for uPVC and metal. This will ensure that you don't harm the material of your door. In certain situations, it may be necessary to use a metal saw to cut the desired shape on a uPVC panel. Wear an eye mask if this is the situation. You could end up inhaling some of the chemicals used in the manufacture of uPVC panel. You can also purchase an entirely new uPVC sheet with a hole already made for the flap for cats. This can be purchased from a specialist company. In this instance, the uPVC panel will be installed in place of the existing glass sealed unit. The cost for this service is between PS100 -PS200.