https://www.selleckchem.com/products/GDC-0941.html Results Depending on the CBCT unit, the CNR values in Roxolid and Zirconium fixtures are completely different. Under higher exposure parameters, the CNR values of the Roxolid and Zirconium fixtures were significantly higher in the maxilla than mandible. However, the fixture size and longitudinal section type did not have a significant effect on the CNR values. Conclusion In contrast to the fixture material, scanning parameters and jaw type, differences in the size and longitudinal section of the fixtures had no impact on artifact severity.The aim of this study was to find the most effective surface preparation methods to enhance the bond strength between the composite resin and surface remaining from ceramic fracture. In this systematic review and meta-analysis, 39 studies were examined. The information related to the studies was extracted and categorized based on the type of the substrate material and applying or not applying thermal cycles (p less then 0.05). In the meta-analysis of substrate metal-ceramic samples without aging, application of air abrasion resulted in a significant increase of the bond strength to composite resin when using chemical compounds of the group without the mentioned functional monomers. Application of mechanical and chemical surface preparation methods can result in enhanced bond strength of the composite to the substrate material, which depends on the type of substrate material.Aim This study investigated the effects of e-waste occupational exposure on lipid profile and atherogenic indices in Waste Electrical and Electronic Workers in South-South Nigeria. Matrials and methods Whole blood levels of lead and cadmium were analyzed using ICPMS (Inductively Coupled Plasma Mass Spectrometry). Total serum cholesterol (TC), high density lipoprotein (HDL) cholesterol and triglycerides (TG) were determined using spectrophotometric method. Low density lipoprotein (LDL) cholesterol value was calcu