https://jsfiddle.net/zbhk7ygm/ How to Repair Broken Car Keys No one likes calling the dealership to buy spare parts for their vehicle. It can be costly and take an extended time to obtain the part. To save money, you can try a DIY solution for your car key that is broken. All you require is a clip and some wire. Drill a hole into the broken end of the key A broken car key is the worst. Not only is it difficult to get into your vehicle, but you also won't be able to start the engine. Fortunately, there are a few things you can do to fix the issue yourself prior to calling an expert. For example, you can try using super glue to join the two ends of the key together. However, this technique should only be used as a last resort because it may harm the ignition or door lock. First, you will need to trim the nail to a suitable length. You will be using it as a connector, so it shouldn't be too long or thick. You can then make a hole in the broken part of your key. Make sure to drill slowly and cautiously. If you're not careful, you may worsen the issue. Avoid using a drill on the ignition as this can cause serious damage. A screw or pin can be used to push the two ends together. You can also use pliers, but be careful not to damage the car key. You can also use a small amount of clear tape to hold both ends of the key together. This will prevent the key from breaking and will allow you to hold it better on it when you take it out. If none of these methods work, you should contact a locksmith immediately. A locksmith can remove the key from the lock of your car and supply you with a spare. They are available 24 hours a day and can respond quickly to your call. In addition, they can assist you in saving money by providing discounts on replacement keys. In some instances, they can even make keys on the spot, so you don't have to wait for a while before getting back on the road. Attach to a connector When your key breaks in the car lock it could be an absolute nightmare. It c