https://brinch-weeks-2.federatedjournals.com/fitting-a-cat-flap-in-a-upvc-door-1730061640 Installing a cat flap might be a bit daunting but it's simple with the right instructions. First, decide how high you would like the flap to be (on average the belly height). Mark this point on the door and then use the template as a guide to drill. If you have a small kitten hold the door open a bit and gradually allow it to enter. Reward it when it goes through. Take a measurement of the door A cat flap allows your pet to move into and out of your home at its convenience. This can help keep your cat healthy by making sure that it is exercising as well as being able to come back in if it is stuck outside in bad weather, particularly in winter. It can also reduce the amount of time you have to spend letting it out or in and can also keep your home safe by letting you know when it's been out. It is important to make sure that the cat flap is installed properly to stop your pet from being forced through it or escaping by other animals (e.g. dogs). It is important to measure the height of your pet's belly as well as the entrance to your home in order to make sure that the flap is at the proper height. If your cat is a little larger or shorter than the normal, you can adjust the position of the flap by moving it up or down by a tiny amount. The next step is to utilize a spirit level mark the centre of the door, where you will put the flap. With the markings as a guideline, you can use an jigsaw to cut the form of the flap within the door. Once you've cut the space, sand down the edges of the door to create smooth surfaces. You can then drill any fixing holes that are required. The process of fitting a cat flap isn't as complicated as you think and it should not take more than two hours to finish the entire task from start to completion. The process is a bit more complicated if you are required to put it in the form of a uPVC door or a composite one. is due to the fact that these do