https://www.repairmywindowsanddoors.co.uk/barnet-cat-flap-installer-near-me/ If you're looking for a way to let your pet inside and out without having to worry about them leaving unwanted "gifts" in the house you should consider purchasing a door panel made of upvc with a cat flaps. This option is cheaper than replacing the entire door and easier to put in. It is possible to put an animal flap on your own uPVC doors however, it's an arduous task that can lead to costly mistakes. Easy to install If you have a cat or dog in your home it is essential to be able to let them into and out of your home. This will help you keep them safe as well as allow you to prevent unwanted draughts and moisture in your home. Additionally, you can also save money on energy by letting your pets help with heating and cooling. Installing a cat flap a uPVC can be a challenge for some homeowners. Fortunately, there are ways to make it easier. First, you must measure the height of your pet. This will enable you to determine the correct height for the flap for your cat. Then, you need to draw the desired shape on the uPVC panel. It could be an oval or a square. It is important to ensure that the cut is precise and that the cut is straight. Once you have created the marking on the uPVC panel, you can make use of a jigsaw to cut out the design. Use a blade that is fine-tipped and is typically marked for uPVC and metal. This will help you avoid damaging the material of your front door. In certain situations it is possible to use a metal saw to cut out the desired shape from a uPVC panel. If this is the case, be sure to wear an eye mask. If you don't, you could get a whiff of some of the chemicals used in the manufacture of uPVC panels. Alternatively, you can get a new uPVC panel that has a pre-made hole for the cat flap. You can purchase this from a specialist. In this case it is a uPVC panel is fitted to replace the sealed glass unit. The cost for this service is between PS100 between PS100 and