https://dokuwiki.stream/wiki/Window_With_Cat_Flap If you're looking for a method to let your pet in and out without worrying about them leaving unwelcome "gifts" within the home look into an upvc door panel that has a cat flaps. This is cheaper than replacing the whole door and is easier to put in. While it is possible to install an animal flap inside your own uPVC door, it's important to know that this is a tricky job that could result in expensive mistakes. Easy to install When you have a pet or a cat living in your home it is crucial to allow them out and in your home. This will help you keep them safe, but also allow you to keep out unwanted draughts or moisture in your home. In addition, you can also save money on energy by allowing your pets to help with heating and cooling. However, putting in a cat flap in a uPVC door can be a challenge for homeowners who aren't experts. There are methods to ease the process. First, you need to measure your pet's height. This will help you determine the ideal height at which to put the flap on. Then, you should draw the desired shape on the uPVC panel. This can be an oval or a square. You should also make sure that the cut is correct and that the cut is straight. After marking the uPVC sheet, you can cut the design using an jigsaw. Make sure you are using a sharp cutting blade that is usually made for use with uPVC or metal. This will prevent you from damaging the material that is used to construct your front door. In some instances, it might be necessary to have a metal saw cut the desired shape out of a uPVC sheet. Wear an eye mask in this case. In the event that you do not, you could get a whiff of some of the chemicals that are employed in the manufacturing of uPVC panels. You can also buy a new uPVC sheet with a hole already drilled for the cat flap. This can be purchased from a specialist company. In this instance the uPVC panel is fitted to replace the sealed glass unit. The cost for this service is between PS100 -PS2